Table of Contents
Advertisement
Step 6: Verification
Follow the steps below to verify the system functionality.
1. Press the
button to enter Auto operating mode. Confirm that 'Auto' is displayed
2. Press the
button to cycle through the different supported fan modes and verify the fan is operational.
3. Verify heating:
a. Press the
button to increase the heat setpoint at least five degrees above the room temperature
b. If
, 'Heat' and 'On' are flashing on the display, this indicates a recovery state, due to equipment protection delays. Heating
will start once these delays expire. See the
c. If the
animates and the words 'Heat' and 'On' are displayed, this indicates that the system has started heating.
4. Verify Cooling:
a. Press the
button to set the cool setpoint at least 5 ˚F below the room temperature.
b. If
, 'Cool' and 'On' are flashing on the display, this indicates a recovery state, due to equipment protection delays. Cooling
will start once these delays expire. See the
c. If the
animates and words 'Cool' and 'On' are displayed - This indicates that the system has started cooling.
Advanced Configuration
Advanced Configuration
29
section for more details.
section for more details.
P/N 032498h
Advertisement
Table of Contents
