Axis Q17 Series User Manual page 22

AXIS Q17 Series
Additional settings
Make sure that AXIS Video Motion Detection is running:
1. Go to Settings > Apps > AXIS Video Motion Detection.
2. Start the application if it is not already running.
3. Make sure you have set up the application according to your needs. If you need help, see the
user manual for AXIS Video Motion Detection 4.
Create a rule:
1. Go to Settings > System > Events and add a rule.
2. Type a name for the rule.
3. In the list of conditions, under Application, select AXIS Video Motion Detection (VMD).
4. In the list of actions, under Recordings, select Record video while the rule is active.
5. Select an existing stream profile or create a new one.
6. Set the prebuffer time to 5 seconds.
7. Set the postbuffer time to 60 seconds.
8. In the list of storage options, select SD card.
9. Click Save.
Record video when a PIR detector senses motion
This example explains how to connect an Axis PIR detector to the camera, and set up the camera to start recording when the
detector senses motion.
Required hardware
• 3-wire cable (ground, power, I/O)
• Axis PIR detector
NOTICE TICE
NO NO TICE
Disconnect the camera from power before connecting the wires. Reconnect to power after all connections are done.
Connect the wires to the camera's I/O connector
Note
For information on the I/O connector, see Connectors on page 31.
1. Connect the ground wire to pin 1 (GND/-).
To watch this video, go to the web version of this document.
www.axis.com/products/online-manual/39799#t10106619
How to record a video stream when the camera detects motion
22