Table of Contents
Advertisement
Chapter 2. Installation
The ADTRAN IQ Probe MIB is available from ADTRAN in the
support section of the ADTRAN Web page at www.adtran.com.
The following items are included in ADTRAN shipments of ESP
DBU cards:
• ESP DBU card
• An 8-position modular to 8-position modular cable for the 4-
Customer Provides
You must provide male interface cables for the DTE and DCE
ports. Use a standard DB-25 cable for EIA-232 or EIA-530, or use
an optional ADTRAN adapter cable for X.21 or V.35. Part
numbers for the optional cables are given later in this chapter in
the section Rear Panel.
For SNMP management not accessed through the DTE or DCE
port, you must provide access to the IQ Probe either through a
SLIP port, Async PPP port (requires a male 25-pin D-type
connector), or a 10baseT ethernet port. See the appendix Pinouts
for the pin assignments of the control port (for SLIP and Async
PPP) and the ethernet port.
Power Up
The IQ Probe is provided with an IEC-type 8-foot power cord,
terminated by a three-prong plug which connects to a grounded
power receptacle with supply voltage from 90-240 VAC.
For international applications, please use the appropriate IEC adapter
cable for power connection.
Power to the IQ Probe must be provided from a grounded 90-240 V AC,
50/60 Hz receptacle.
8
wire SW56 and ISDN DBU options or an 8-position modular to
4-position modular cable for the V.34 DBU option
IQ Probe User Manual
61200214L1-1
Advertisement
Table of Contents
