Table of Contents
Advertisement
1-3-1 Video/Audio Inputs
The following sections specify the video/audio inputs for P42S351
1-3-1-1 TV Antenna Interface
①. TV Antenna Connector
P42S351 shall provide a f-type cable connector with 75 ohms termination on its back panel for
reception of radio frequency signals.
②. TV Systems
PAL/SECAM
③. TV Channel Coverage
the RF tuner shall be capable of covering 48.25MHZ to 863.25MHZ and tuning to the following
channels:
1-3-1-2 Component Intputs
We have AV input jacks for VIDEO/AUDIO and S-VIDEO/AUDIO.
COMPONENT1 INPUT
COMPONENT2 INPUT
If your DVD or VCD player is equipped with Y PbPr(Y Cb Cr) signal output, you can connect these
signals to the component signal input end of the TV to get better image quality, as the figure shows.
Note: when you find picture scrolling,
above,e check the connection. Please check if the color of the cable matches the color of the
input socket.
1-3-1-3 PC Input
P42S351 accommodates a VGA type computer connection as specified below.
①. Connect D-SUB signal cable（VGA cable, RGB cable）from PC to D-SUB jack at the back
of this TV Set. And connect the earphone cable from PC earphone output jack to AUIDO
input jack near to the D-SUB jack.
Setup:
Use the key "SOURCE" in Remote Control or "MODE" key on the front control keypad, select the
/
/
Y
Pb Cb
Pr Cr
/
/
Y
Pb Cb
Pr Cr
the
Page 9 of 99
L
R
L
R
wrong color or no color, no image or all
of the
Advertisement
Table of Contents
