3. Press the AC power switch. It will show the duologue window when PDP and PC connect correct. LED is
red(If the connect is not correct,it will retain like figure 1,and the PDP will open, LED is blue ) press
"confirm";
4. Click config key, will show duologue window like figure 3:choose the type of Flash at Chip duologue
window, if the chip is AMIC ,it will choose MX29LV040,SST should be choose SST29SF040,other
option should the same with picture. Then click OK key;
5.
Click BIN, it will show duologue window as picture 4 ,choose the *.bin file ,click open key
figure 2
figure 3
figure 4
Page 39 of 99