Heat Pump Disassembly; Float (Safety System) - Bosch Ascenta SHX3AM Repair Instruction

When reassembling fascia panels to doors, make sure fascia
panel tabs insert outer door slots.
5.5

Heat pump disassembly

Disconnect support strap and wire harnesses. Either unscrew (4)
screws to separate adapter from base or remove hose clamp to
separate pump from adapter.
removed from the heat pump. To remove pump, slide pump off
sump at seal ring.
Replacement heat pump comes with motor, pump, seal ring and
hose clamp.
Motor can't be separated from pump and seal ring can't be field
installed.
702_58300000130262_ara_en_b
The seal ring can't be field
Seal ring
Adapter
5.6

Float (safety system)

The float is best accessed from the bottom.
pieces snap into place and must be carefully removed in
sequence.
Unscrew the one housing screw, then squeeze cover tabs to lift
up cover from float assembly. Cover can be snapped from hinge
on float assembly.
Float lever has tabs which lock onto the knob of the push rod.
Carefully pry the tabs away from the push rod knob, lift up the
lever and pry the lever from its hinge.
Several plastic
Page 17 of 27