1. Press the "
message "Please press power button again to complete the shutdown
process. Warning: DO NOT unplug while the projector fan is still
running." displayed on the projector's screen. Press the "
again to confirm, otherwise the message will disappear after 5 seconds.
2. The cooling fans continue to operate for about 60 seconds for cooling
cycle and the Power LED will keep blue.
When the Power LED begins flashing, the projector has entered
If you wish to turn the projector back on, you must wait until the
projector has completed the cooling cycle and has entered standby
mode. Once in standby mode, simply press "
3. Disconnect the power cord from the electrical outlet and the projector.
4. Do not turn on the projector immediately following a power
When the "LAMP" indicator lights solid red, the projector will
automatically shut itself down. Please contact your local reseller or service
When the "TEMP" indicator lights solid red for about 20 seconds, it indicates
the projector has been overheated. The projector will automatically shut itself
Under normal conditions, the projector can be switched on again after it has
cooled down. If the problem persists, you should contact your local dealer or
our service center.
When the "TEMP" indicator solid red for about 10 seconds, Please contact
your local dealer or our service center.
Powering Off the Projector
" button to turn off the projector lamp, you will see a
" button to restart the