Usi G The Projector; Powering On / Off The Projector - Acer XL1220 User Manual

UsI G THe PRoJeCToR

Powering on / off the projector

Powering on
1. Remove the lens cap.
Securely connect the power lead and signal/source cable. When connected, the Power LED will turn
2.
red.
3. Turn on the projector by pressing the
A start up screen will display in approximately 10 seconds and the Power LED will turn blue or green.
4.
otee: The first time the projector is turned on, you will be prompted to select the preferred language, projection
orientation, and other settings.
Powering off
1. Turn off the projector by pressing the
2. The following message will be displayed:
3. Press the
you press the
4. When the Power turns solid red, this indicates the projector has entered standby mode. If you wish
to turn the projector back on, you must wait until the cooling cycle has finished and the projector has
entered standby mode. When the projector is in standby mode, simply press the
turn on the projector.
5. Disconnect the power lead from the electrical outlet and the projector.
otee:
It is not recommended that the projector is turned on immediately, right after a power off procedure.
22
English
Lens cap
button again to confirm, otherwise the message will disappear after 10 seconds. When
button for the second time, the projector will shut down.
or
button on the projector keypad or remote control.
button on the projector keypad or remote control.
Power Off
Power Off?
Press power key again.
button again to