Note: This screen capture function is limited by 4:3 aspect ratio only.
Note: For XGA models, to get best quality for you desired image, suggest
end-user set PC resolution to 1024 x 768 before you use this function.
Note: For SVGA models, to get best quality for you desired image, suggest
end-user set PC resolution to 800 x 600 before you use this function.
Lamp Hour Elapse
Displays the lamp's elapsed operating time (in hours).
Activate this function to display a reminder to change the lamp 30
hours before its expected end-of-life.
Lamp Hour Reset
This projector provides an excellent security function for the
administrator to manage usage of the projector.
is enabled, you must enter "Administrator Password" first before
changing the security settings.
Once "Security" is activated to "On", the administrator can set
after choosing "Yes" to turn the lamp hour counter to 0 .
to change the "Security" setting. If the security function
Select "On" to enable the security function. The user has to
enter a password to operate the projector. Please refer to
"User Password" section for details.
If "Off"is selected, then the user can turn on the projector
to select timeout interval.
The range is from 10 minutes to 990 minutes.
When the time is up, the projector will prompt the user to
enter the password again.
The factory default setting of "Timeout(Min.)" is "Off".
Once the security function is enabled, the projector will
request user to enter password when switch on the projector .
Both "User Password" and "Administrator Password" can be
accepted for this dialogue.