Image is stretched
when displaying a
Image is too small
or too large
Image has slanted
Image is reversed
Problems with the Projector
The projector stops responding
to all controls
Lamp burns out or makes a
When you play a DVD encoded in anamorphic or 16:9
aspect ratio you may need to adjust the following
If you play an Letterbox(LBX) format DVD title,
please change the format to Letterbox(LBX) in the
If you play a 4:3 format DVD title, please change the
format to 4:3 in the projector OSD.
If the image is still stretched, you will also need to
adjust the aspect ratio. Set up the display format to
16:9 (wide) aspect ratio on your DVD player.
Adjust the zoom lever on the top of the projector.
Move the projector closer to or further from the
Press "MENU" on the remote control or no the
control panel. Go to "Image setting --> Aspect
Ratio" and try different settings.
If possible, reposition the projector so that it is
centered on the screen.
Press the "Keystone
panel or the remote control until the sides are
Select "Image --> Projection" on the OSD and adjust
the projection direction.
If possible, turn off the projector, then
unplug the power cord and wait at least 30
seconds before reconnecting power.
When the lamp reaches the end of its useful
life, it will burn out and may make a loud
popping sound. If this happens, the projector
will not turn on until the lamp module has
been replaced. To replace the lamp, follow
the procedures in the "Replacing the Lamp"
" button on the control