Choose "On" to dim the projector lamp which will lower power
consumption, extend the lamp life and reduce noise. Choose "Off"
to return normal mode.
The projector will auto shutdown while there is no signal input
after the allocated time. (in minutes)
When source lock is turned "Off", the projector will search for
other signals if the current input signal is lost. When source lock is
turned "On", it will "Lock" the current source channel unless you
press "SOURCE" button on the remote control for next channel.
Choose the Menu location on the display screen
Use this function to select your desired startup screen. If you
change the setting, the changes will take effect when you exit the
Use this function to customize the startup screen. To capture the
image that you want to use as the startup screen, follow the
Before proceeding with the following steps, make sure that the
"Keystone" is set to the default value 0 and the aspect ration is set
to 4:3. For details, refer to the "Image Setting" section.
Acer: The default startup screen of Acer projector.
User: Use memorize picture from "Screen Capture" function.
Change the "Startup Screen" from the default setting "Acer"
Press "Screen Capture" to customize the startup screen.
A dialog box appears to confirm the action. Choose "Yes" to
use the current image as your customized startup screen. The
capture range is the red rectangular area. Choose "No" to
cancel the screen capture and exit the onscreen display (OSD).
A message appears, stating that the screen capture is in
When the screen capture is finished, the message disappears
and the original display is shown.
The customized startup screen, as shown below, take effect
when there is a new input signal or when you restart the