Table of Contents
Advertisement
4. Solder the new 40-pin connector to the harness
(CAMERA).
5. Attach the new 40-pin connector in the reverse order
of removal.
n
When attaching the sheet (40P), check to see that its
camber is oriented to the 40-pin bracket.
Stepped
screws
6. Check that the 40-pin connector moves by hand.
40-pin connector
1-10 (E)
40-Pin bracket
Camber
Sheet (40P)
1-10. Notes on Replacement of V Shoe
The installing position of V shoe influences the precisely
position when installing the unit to the camcorder. Tighten
the three screws sequentially in accondance with the figure
when installing the V shoe on the main chassis. When the
V shoe is replaced, check that the specification is met.
Specification: a _ b = 0 ± 0.1 mm
a
1
1-11. Settings after Replacing the Boards
and EL Display
When the following boards and the EL display are re-
placed, implement the specified settings referring to the
following Section.
For other boards described in the following do not require
setting when they are replaced.
Board name
Setting (Section to be referred to)
IF-914 board
Serial No setting (Section 1-14)
MB-998 board
Setting S2-1 and S2-2 on the MB-998 board
(Section 1-6)
EL display
Timer reset (Section 1-15)
b
3
2
WLL-CA50
Advertisement
Table of Contents
