Table of Contents
Advertisement
3.8
Installation of the collecting trays on GT40
For the transport of the GT40, the collecting trays (3) were dismantled on both sides.
Fix the collecting trays to the machine body again with the enclosed M6 hexagon bolts.
3
3.9
Cleaning the machine
ATTENTION!
Do not use compressed air to clean the machine.
Your new surface grinding machine must be completely cleaned after unpacking in order
ensure that the moving parts and sliding surfaces cannot be damaged during operation of the
machine Before delivery, all bare parts and sliding surfaces of each unit are lubricated accord-
ingly in order to protect them against rust in the period before commissioning. Remove all wrap-
pings and clean all surfaces with a degreaser to soften and remove protective greases and
coatings.
Wipe all surfaces with a clean cotton cloth.
EN
GT25 | GT30 | GT40
30
Translation of original instructions
Version 1.0.2 - 2020-09-15
Advertisement
Table of Contents
Need help?
Do you have a question about the Optigring GT 25 and is the answer not in the manual?