Introduction; Document Purpose; Reference List Of Commissioned Pm Motors - Siemens SINAMICS G120X Commissioning Manual

1 Introduction

Introduction
1
1.1

Document purpose

It provides guidance for commissioning permanent magnet synchronous motors (PMSM) with
SINAMICS G120X drives using the IOP-2 interface. Despite the fact the PMSM motors are not
standardized and the optimal performance with G120X drive cannot be always guaranteed most
rd
3 party PMSM motors that meet the criteria described in this guide can be successfully
commissioned.
1.2

Reference list of commissioned PM motors

This document contains information based on several successful tests with PMSM motors.
So far the biggest power rating of the motor that was tested with G120X inverter is
18.5kW/400V. For that reason the information provided in this guide is currently
restricted to applications of up to 18.5kW.
Table 1-1
Make
Hanning
VEM
VOLT
Pro
KSB
KSB
G120X commissioning guide for permanent magnet motors PMSM
Entry-ID: 109780815, V1.0,
Type Design
P3S120-040P0110- IPM
030-003-HS0-029
IE5-PS2R 90 S 4 H SMPM
TMP140
IE5 - 80 IPM
UMA-S 150E 7/42 IPM
Submersible
borehole motor
UMA-S 150E 18/42 IPM
Submersible
borehole motor
07/2020
kW rpm V Hz
1.1 3000 310 150
1.5 3000 310 100
1.5 3000 300 250
4 3000 400 100
18.5 3000 400 100
Poles Lq/Ld Note
6 1.3 Lq, Ld set
according to data
sheet
4 1 Lq, Ld set
according to data
sheet
10 1.1 ID run ok. Tested
up to 200Hz.
4 1.7 Nominal voltage
corrected to
331V. Lq, Ld set
according to data
sheet values.
Tested with sine-
wave filter.
4 1.6 Nominal voltage
corrected to
366V. Lq, Ld set
according to data
sheet values.
Tested with
du/dt+VPL and
sine-wave filter.
3