Installation Of Optional Boards - Sony DNE-1000 Maintenance Manual

1-8. Installation of Options
1-8-2. Inserting/Pulling Out of Plug-in Boards
c
To avoid shock hazards and/or damage to the plug-in
boards, be sure to turn off the power switch before insert-
ing or pulling out the plug-in boards.
1. Open the front panel. (Refer to the section 2-1-1.)
2. Remove the five screws and the board retainer.
Removal
3. Open the eject levers of the plug-in board in the
direction of the arrow 1.
4. Pull out the plug-in board from the unit.
n
Pull out the plug-in board with an equal force for both
eject levers.
Installation
5. Insert the plug-in board along the board guide rails
while putting the eject levers to 1 position as shown
in the figure.
6. Connect the plug-in board to the connector on the
mother board while putting the eject levers in the
direction of the arrow 2.
7. Install the board retainer in the reverse order of the
steps 1 through 2.
n
When installing the board retainer, secure them with
the screws (B 3x6) that are packed with DNE-1000.
Eject levers
Board retainer
Board
BVTT Board guide rail
3x5
BVTT 3x5
1-22(E)
To insert the board
2
To pull out
1
the board

1-8-3. Installation of Optional Boards

There are the two installation types of the optional boards
in DNE-1000.
<Type 1> The type that the optional board is inserted in
the slot.
<Type 2> The type that the optional board is connected to
the connector of the pre-installed board.
The installation procedures are described below.
<Type 1>
This Type's Optional Boards
Slot No.
1
4
5
1. Install the optional board. (Refer to the section 1-8-2.)
Optional board
XPT-9 board (BKNE-1030)
SEC-39 board (BKNE-1040)
VSW-45 board (BKNE-1040)
DNE-1000