Input And Output Signals Of Connectors; Dne-1000 - Sony DNE-1000 Maintenance Manual

1-4. Input and Output Signals of Connectors

The input and output signals of the connectors on the rear
panel are specified in the following table.
And refer to the following illustration for the pin positions
of the connectors.

1-4-1. DNE-1000

PGM OUT MONITOR
AUX INPUT
1/2
3 1 L
R
4 2 3/4
REC TC IN
PANEL GUI
GPI RS232C
D-sub 25-pin Female
13
25
14
D-sub 15-pin Female
8
1
PANEL
GUI
15 9
PRIMARY INPUT : SDI Digital video (BNC)
DIGITAL OUTPUT : SDI Digital video (BNC)
Serial digital (270 Mbits/second)/SMPTE 259M/
ITU-R BT.656III
WORD SYNC OUTPUT : (BNC)
Word clock, TTL level (48.0 kHz)
REF IN : Analog video (BNC, roop through out)
Black burst or composite sync
0.3 Vp-p, 75 Z, sync negative
DNE-1000
DEVICE CONTROL
F (LOCAL DISK) A (LOCAL DISK)
G B
H (LOCAL DISK) C (LOCAL DISK)
I D
J E
D-sub 9-pin Female
1 5
GPI
9
D-sub 9-pin Male
1
6
<EXT VIEW>
WORD SYNC
PRIMARY INPUT
OUTPUT
IN5
1
2 IN6
REF IN
IN7
IN8
DIGITAL OUTPUT
EDIT PVW PGM
1
2
CAPTURE
1
DEVICE CONTROL
6
5
RS232C
9
MONITOR : (XLR 3-pin, Female)
+4 dBm (600 Z at load), low impedance, balanced
REF TC IN : (XLR 3-pin, Male)
0.5 through 18 Vp-p, 10 KZ, balanced
AUX INPUT : AES/EBU Digital audio (XLR 3-pin, Male)
PGM OUT : AES/EBU Digital audio (XLR 3-pin, Female)
AES/EBU format stereo mode, balanced
1-4. Input and Output Signals of Connectors
IN1
IN2
IN3
IN4
1
2
3
AC IN
1-3(E)