2-3. BKNE-1011
2-3-1. Removal of Exterior Parts
2-3. BKNE-1011
2-3-1. Removal of Exterior Parts
c
c
c
c
c
. To avoid shock hazards and/or damage to the mounted
circuit boards, be sure to turn off the power switch of
DNE-1000 before inserting or pulling out the exterior
parts.
. To avoid shock hazards and/or fire by a short circuit, be
sure to set the removed exterior parts on the places that
will not be established a short circuit.
Because the exterior parts are conductive-coated.
1. Turn the fader grip in the direction of the arrow and
remove it.
Fader grip
2-6(E)
2. Remove the four knobs and the five slide knobs.
Knobs
3. Remove the four screws and the upper panel assembly
from the lower case.
n
When installing the upper panel assembly, be careful
not to damage the screw hole by strongly tightening.
4. Disconnect the two connectors (CN7 and CN8) on the
CPU-207 board.
CPU-207 board
Lower case
Slide knobs
Upper panel assembly
CN7
BVWH 3x8
(GIZA TITE)
BVWH 3x8
(GIZA TITE)
DNE-1000