1-7. Attachment of Control Panel (BKNE-1010/1011)
1-7-3. Connection of Control Panel
Use the two D-sub cables included with DNE-1000 and BKNE-1011, and connect the control panel
(BKNE-1010/1011) to DNE-1000.
(Figure for Connection)
D-sub 15-pin cable (Included with DNE-1000)
PANEL
(Female)
DNE-1000
(Rear Panel Block)
DNE-1000
[PANEL] connector
(D-sub 15-pin Female)
1. BKNE-1010
(1) Select "MODE" switch at the rear side of BKNE-1010 to the 1.
(2) Connect the one D-sub 25-pin cable included with DNE-1000 between "PANEL" connector of DNE-
1000 and "EDITOR" connector of BKNE-1010.
2. BKNE-1011
(1) Connect the one D-sub 25-pin cable included with BKNE-1011 between "FADER PANEL" connec-
tor of BKNE-1010 and "CONTROL PANEL" connector of BKNE-1011.
1-18(E)
D-sub 25-pin cable (Included with BKNE-1011)
EDITOR
FADER PANEL
(Male)
(Female)
BKNE-1010
[FADER PANEL] connector
(D-sub 25-pin Female)
CONTROL PANEL
(Female)
BKNE-1011
BKNE-1010
[MODE] switch
[EDITOR] connector
(D-sub 15-pin Male)
BKNE-1011
[CONTROL PANEL] connector
(D-sub 25-pin Female)
MODE
1 2
DNE-1000