Furuno WR2120 Operator's Manual page 53

3-1) AUTO_FTP.bat operation environment setting (no need to change)
It specified the folder that stores AUTO_FTP.bat. Please do not change this item.
DIR = C: ＼ Users ＼ radar ＼ FURUNO ＼ WR_transfer
3-2) Set the observation data file reception monitoring
e.g.) If the FTP destination folder is set to drive D drive WR_transfer ＼ FTP, then
CHK_DIR = D: ＼ WR_transfer ＼ FTP
3-3) Set the FTP destination folder
Specify the FTP destination folder of the observation data file.
e.g.) If the FTP destination folder is set to test 2, then TRS_DIR = test 2
4. Set the FTP_WR_FTP.ini
Set information of FTP server.
4-1) Set the FTP server
Specify the name or IP address of the FTP server.
e.g.) If using localhost as FTP server, then
FTPSERVER = localhost
4-2) Set the FTP user
Set the FTP user name and password.
e.g.) If the FTP user is a xrain user, and the password xrain is set by the xrain user, then
USER = rainmap
PASSWORD = rainmap
4-3) Set the passive mode
0: Active mode (Default: 0), 1: Passive mode
e.g.) If passive mode is set to passive mode
PASSIVEMODE=1
5. Set when not transferring FTP
It is necessary to change two files, WR_transfer.bat and AUTO.bat when FTP transfer is not
performed.
5-1) Change the WR_transfer.bat
Change the setting of not to let AUTO_FTP.BAT start when WR_transfer.bat is calling.
Change it as follows:
Before change: start AUTO_FTP.BAT
After change: @rem start AUTO_FTP.BAT
Figure 4.6: Sample of FTP_WR_FTP.ini
FTP user name
FTP password
44
S2E-17-0208_OM_WR2120_C