Advertisement
Installation to Metal Stud Walls
FOR METAL STUD WALLS ONLY: Drill four 1/2"
1
(13mm) dia. holes through drywall and studs at lo-
cations corresponding to wall plate. Insert togglers
(G) as shown below...
Skip to Step 2 page 7
WARNING
• Product must be mounted through drywall that has a
minimum thickness of 1/2" and into metal studs, 26
gauge or heavier.
• Make sure that togglers are anchored into the center
of the studs as shown in figure 1. The use of an
"edge to edge" stud finder is highly recommended.
1-1
Pivot end of
toggler (G).
1-2
Push into hole.
1-3
Rotate toggler (G)
clockwise to wedge it
against inside walls
of metal stud.
1-4
Slide plastic cap
forward while pulling
back firmly on ring.
1-5
Break off excess.
3-6
Align wall plate with
hole in wall and
fasten using 1/4-20 x
2.5" screw (H).
Skip to Step 5
G
wall plate
H
5 of 9
STUD
G
fig. 1
H
ISSUED: 03-02-11 SHEET #: 125-9192-1
B
Advertisement
