Table 5: Error Codes 400-499: Motion Errors
Error
Code
400
401
402
403
Table 6: Error Codes 500-599: NVRAM Errors
Error Code
500
501
502
503
504
505
For all other error messages (codes not listed here), please contact your local Molecular
Devices representative for assistance.
Opening the Drawer Manually
If an error occurs while the drawer is closed and you need to remove a plate.
If the drawer does not open, turn power to the instrument off and then on again.
If the drawer remains closed, turn the incubator off (if it was on).
If the drawer still remains closed, power off the instrument and unplug the power cord.
Then try to use a blunt, flat object (such as a spatula) to open the door. With your index
finger, pull the plate drawer out of the instrument (do not force the drawer) and remove the
plate. This action will not harm the instrument, but should only be taken if the first two
options fail to open the drawer.
If you are still unable to open the drawer, contact your local Molecular Devices representative.
5065390 C
Error Message
Notes
carriage motion
Carriage did not move to either of its photo interrupts in a reasonable
error
time, or cannot find its photo interrupt.
filter wheel
Filter wheel did not move to its photo interrupt in a reasonable time, or
error
cannot find its photo interrupt.
grating error
Grating did not move to its photo interrupt in a reasonable time, or
cannot find its photo interrupt.
stage error
Stage did not move to its photo interrupt in a reasonable time, or cannot
find its photo interrupt.
Error Message
NVRAM CRC corrupt
NVRAM Grating cal data bad
NVRAM Cuvette air cal data error
NVRAM Plate air cal data error
NVRAM Carriage offset error
NVRAM Stage offset error
Chapter 6: Troubleshooting
Notes
The CRC for the NVRAM data is corrupt.
Grating calibration data is unreasonable.
Cuvette air calibration data is unreasonable.
Plate air calibration data is unreasonable.
Carriage offset data is unreasonable.
Stage offset data is unreasonable.
31
Need help?
Do you have a question about the SpectraMax ABS and is the answer not in the manual?