HPE Aruba AP-MNT-W4 Installation Manual page 2

4. Pushing towards the solid surface, rotate the AP clockwise until it clicks into place (see
Figure 2
AP-to-Adapter Option
This mounting option works only with a wall.
1. Place the adapter against the back of the AP with the adapter at an angle of approximately 30 degrees to the
tab (see
2. Twist the adapter clockwise until it snaps into place in the tabs (see
Figure 3
3. Install two screws (and wall anchors if necessary), one above the other. Do not fully insert the screws into the
wall. Leave enough space between the screw head and the wall for the adapter.
4. Align the keyhole slots on the back of the adapter with the screws installed in step 3.
5. Place the larger opening on the keyhole slot over the screw and pull the AP down until it is securely attached
to the screws (see
Figure 4
2
Attach the AP to the Adapter
Figure 3).
Adapter Installation
Figure 4).
AP-Adapter Wall Installation
Figure
Figure 3).
AP-MNT-W4 Mount Kit | Installation Guide
2).