Options; Configuration - ResMed AirSense S10 Clinical Manual

Options

Parameter Description
Essentials Set the level of access available to the patient.
™
SmartStart Enable / disable the SmartStart feature. If you enable the SmartStart
feature, the device will start automatically when the patient breathes into
the mask and then stop automatically when the patient removes the
mask.
Reminders
Mask Set a recurring reminder to the patient to replace the mask.
Water tub Set a recurring reminder to the patient to replace the water tub.
Tube Set a recurring reminder to the patient to replace the air tubing.
Filter Set a recurring reminder to the patient to replace the air filter.

Configuration

Parameter Description
Language Set the display language.
(Not all languages available in all regions.)
Date Set the current date.
If you set a new date that occurs in the past then an error message is
displayed. Before this change can be made, erase the compliance data
available under the Configuration menu.
Time Set the current time.
If you set a new time that occurs in the past then an error message is
displayed. Before this change can be made, erase the compliance data
available under the Configuration menu.
Press. Units Set the unit of pressure in which pressure is displayed.
Temp. Units Set the temperature units.
Restore Reset to default settings (except for language, date and time).
Defaults
Erase Data Erase all data stored on the device and the SD card. Settings, date, time
and device run hours are not affected.
About View Run Hours, SN, SW, provider, type, service and signal strength of
the device, CX number, humidifier and internal modem.
Range
On / Plus
Off / On
Off / 1– 24 mths, 1 month
increments
Off / 1–24 mths, 1 month
increments
Off / 1–24 mths, 1 month
increments
Off / 1–24 mths, 1 month
increments
Selection
English / Français / Español /
Português
DD Mmm YYYY
24 hours
cm H O / hPa
2
°F / °C
Yes / No
Yes / No
English 17