Table of Contents
Advertisement
21 October 2011
17.
Being that the RPM
signal is critical you will need
to solder the connection.
Using wire strippers create a 1"
window/gap in insulation of the
wire.
Then strip about 1" of insulation
of the RPM signal wire of the
BLUE wire from the PAS wiring
harness.
Wrap the copper wire around the
factory RPM signal wire and
solder this connection.
Then use electrical tape to wrap
this connection so that it is water
tight.
You can also cut the factory
crank signal wire and use heat
shrink tubing if you would like.
18.
Next
on
harness, connect the BLACK
and
RED
wires
respective
connections.
(Driver's Side Battery).
US Shipping Address: 88-446 Harrison St, Sumas, WA 98295 US Mailing Address: PO Box 231, Sumas, WA 98295
Ford 6.7L 2011-2012 Positive Air Shutoff
the
wiring
to
the
battery
BD ENGINE BRAKE, INC.
Plant Address: A10-33733 King Rd, Abbotsford, BC, Canada V2S 7M9
Phone: 604-853-6096 Fax: 604-853-8749 Internet: www.bd-power.com
Solder the connection and then wrap
and seal with electrical tape
15
Advertisement
Table of Contents
