Osd Security - ATEN Master View CS-138A User Manual

OSD Security

In order to prevent unauthorized access to the computers, the OSD provides a
password security feature. If a password has been set, the OSD will request that
the user specify it before allowing entry.
Password:
To set a password:
1. Highlight this item, then press [Enter].
You are presented with a screen that allows you to key in your password.
The password may be up to 8 characters long, and can consist of any
combination of letters and numbers (A - Z, 0 - 9).
2. Key in the new password, then press [Enter].
You are asked to key the password in again, in order to confirm that it is
correct.
3. Key in the new password again, then press [Enter].
If the two entries match, the new password is accepted and the screen
displays the following message:
SET PASSWORD OK
If the entries do not match, the screen displays the message:
PASSWORD NOT MATCH
in which case you must start again from the beginning.
Note: To modify or delete a previous password, access the Password
function as in Step 1, above, then use the backspace or delete key
to erase the individual letters or numbers.
- 24 -