Radius Insert Positioner - Promotech BM-16 Operator's Manual

4.4. Radius insert positioner

Allows the guide to be set properly for bevelling with a radius of 2, 3, 4, or 5 mm.
Part number:
UST-0509-16-00-00-0
Unplug the machine from the power source, place the machine upside down, and
then lower the sleeve to access the cutting inserts. Next, place the positioner from the
top (1, Fig. 16) so that the edge marked with a given radius is aligned with the edges of
three cutting inserts with the same radius (2). Finally, rotate the sleeve (3) so that the
guide makes contact with the positioner (4).
2
Fig. 16. Adjusting the guide for bevelling with radius
Copying, using, or distributing without permission of PROMOTECH is prohibited.
R2
R4
1
3
This document is protected by copyrights.
22
BM-16
R3
R5
4