Promotech BM-16 Operator's Manual page 17

BM-16
Rotate the sleeve to set '0' on the pitch (1, Fig. 12), and then use the 6 mm hex
wrench to loosen the guide rollers (2) and separate them from each other as far as
possible. Place the machine on a vertically positioned pipe, pressing the roller 3 to
the pipe, and then move the rollers 4 symmetrically to join them to the pipe and
tighten in this position. Next, separate the machine from the pipe, and set the
required parameters (5). Then, start the machine, slowly slide it toward the edge, and
bevel according to the direction 6.
2
1
2
4
3
4
6
5
Fig. 12. Using the machine on a pipe
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
17