Startup And Operation; Installing And Removing The Milling Head - Promotech BM-16 Operator's Manual

Bevelling machine
Table of Contents

Advertisement

3. STARTUP AND OPERATION

3.1. Installing and removing the milling head

Unplug the machine from the power source. To install the milling head, place it on the
spindle (1, Fig. 3), and then press and hold the spindle lock button 2 and tighten the
head using the 14 mm hex wrench (3). Next, remove the nut (4) and assemble the
roller with the pivot pin using washers (5), and then place the roller on the milling head
(6), press and hold the button 2, and tighten the roller with the 5 mm hex wrench (7).
Use such a number of washers to keep a little gap between the roller and the cutting
inserts (8). The number of 0.5-mm and 0.1-mm washers needed depends on the
milling head used.
6
1
Copying, using, or distributing without permission of PROMOTECH is prohibited.
5
2
7
3
Fig. 3. Installing the milling head
This document is protected by copyrights.
INCORRECT
(collision
between
roller and
cutting insert)
Washers
8
CORRECT
unused
4
INCORRECT
Distance
washers
(too large gap
between roller
and cutting
insert)
8
BM-16

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents