Table of Contents
Advertisement
Dosaodor-D
The display will be lit and the first Programming page
appears identified by LOC:00.
The displayed texts are in ENGLISH. To switch to other
Languages you only need to press the ENT key.
If any other indicators light up besides those mentioned
above, the following procedures must be performed:
•
Insert and set the Programming enabling key to the
PROGRAMMING - ON position
•
Press the ALARM RESET key
•
Set the key back to the PROGRAMMING-OFF position
If the FLOW - COMPUTER ALARM indicator is still lit after
having performed the procedures described above, you
must check the flow computer status and/or the control unit
and the computer for proper wiring.
After verifying that the above procedures are met you may
proceed with programming the remaining data required for
the correct operation of the system.
If you only want to Reset the Totalized Data and not change
the Programmed Configuration Data, proceed as follows:
•
Remove the Power Supply
•
Set the key switch to PROG-ON.
•
Raise the magnetic thermal switch, which is located next
to the electronic control unit, (supply the main Power),
while keeping the ENT key pressed. This procedure
switches on the control unit and performs a complete
Reset on the Totalized Data (Day and Month).
Programming Sequence
The following are the procedures to be performed for
displaying / modifying the programming data required for
operation of the system:
a)
Press the LOC key to activate the memory Location
selection to be displayed. The symbol Loc:** will appear
on the far left of the first line, indicating that the cycle is
in the phase of selecting a new location.
b)
Enter the specific location number (see table in the
following section). Each location must be expressed
with two characters. Enter the numbers 01 to call up
location no. 1. The keys pressed will replace the "**"
symbols appearing after the letter "L" In case of any
errors in entering the numbers simply press the "CLR"
key to delete them.
c)
As an alternative to the procedure outlined above, it
is also possible to scroll forward or backward by one
location at a time through the contents of the display by
simply pressing the Up / Down arrow keys.
26
d)
A "*" symbol will appear on the far right of the
appropriate line on the display if the displayed
parameter is enabled for programming. It can be
modified as follows:
ensure that the programming key is positioned on
PROGRAMMING - ON and then press the ENT key.
All digits expressing the setting take on the value of "_"
and the star positioned on the far right, changes to an
"i" to indicate the "enter" mode.
e)
At this point, enter the new setting to be programmed.
The numbers entered will automatically be transferred
from the right to left. Any number occurring in entering
the setting can be deleted by simply pressing the CLR
key once for each character to be deleted.
f)
Press the ENT key to confirm the setting. The value
shall be re-written by replacing the "_" limit characters
with "0". The indicator "i" replaced with the "*" symbol.
Parameters belonging to Locations from
Loc:00 to Loc:09 are the programmable
data for the user. The others cannot be
modified. Thus, such data do not show the
"*" indicator.
g)
The first data of Location Loc:00 has a special function.
It is used to select the language in which the messages
displayed will appear. To change the language used,
after having enabled the programming mode by turning
the access key, simply press the ENT key. At this point,
the messages in the new language entered in the
memory will be activated (Display + Printer + Data)
h)
The PRN key opens a menu used to select the report
type you want to print. Press the key to start printing:
1) Programmed Data 2) Daily Report 3) Event Report
Note: Printing is possible ONLY provided
that a "Printer Interval" is programmed in
LOC:03 different from 00:00
CAUTION
Advertisement
Table of Contents
