Advertisement
14. With the help of an assistant, tilt machine and
remove 2x4 block from beneath machine and
mobile base frame, and set machine on the
floor.
Note: When moving the mobile base, the rub-
ber feet should not touch the floor. Likewise,
when operating the machine, ensure that the
rubber feet are fixed firmly against the floor to
provide stability.
Adjusting Rubber Feet
The height of the rubber feet can be adjusted
to stabilize the machine. To ensure the machine
does not move during operations, always make
sure the adjustable rubber feet (see Figure 20)
are firmly touching the ground before operating
the machine.
Tool Needed
Open-End Wrench 17mm .................................. 1
To adjust rubber foot height:
1.
Loosen hex nut on each foot to allow foot
(see Figure 20) to move up or down as
needed.
Figure 20. Rubber foot and hex nut adjustment.
2.
With all casters on the ground, lower each
foot to firmly touch the ground without lifting
caster.
3.
Tighten hex nut on each foot.
T31566 Mobile Base (Mfd. Since 08/19)
Qty
Hex
Nut
Rubber Foot
4.
Raise foot pedals up to lift rubber feet and
move machine (see Figure 21).
Figure 21. Foot pedal raised.
IMPORTANT: When moving the mobile base, the
rubber feet should not touch the floor. Likewise,
when operating the machine, ensure that the rub-
ber feet are fixed firmly against the floor to provide
stability, without lifting casters.
Foot Pedal
-7-
Advertisement
