Advertisement
7.
Attach swivel casters to each rear bracket
with (4) M8-1.25 x 16 hex bolts and (4)
M8-1.25 lock nuts (see Figure 16).
Note: There is limited space when install-
ing fasteners inside the bottom of the caster
wheels.
Hex Bolt
(1 of 4)
Lock Nut
(1 of 4)
Figure 16. Swivel caster attached to corner
bracket.
8.
With the help of an assistant, lift rear side
of machine, then place a 2x4 block under
machine (see Figure 17).
9.
Slide each of the rear brackets onto remain-
ing side rail, and slide assembly into rail-
bracket assembly from Step 6. Adjust fit until
rail-bracket assembly rests against machine
body (see Figure 17).
12" 2x4
Figure 17. Rear brackets and rail placed around
back of machine, which is raised up with a wood
block.
-6-
10. Secure rail to rear brackets with (4) M8-1.25
x 16 hex bolts, as shown in Figure 18.
Figure 18. Remaining rail-bracket assembly
Swivel
Caster
11. With the help of an assistant, shift machine to
remove 2x4 block.
12. With the help of an assistant, tilt machine,
and insert a 2x4 block beneath machine and
mobile base frame (see Figure 19).
Note: Use caution when tilting machine sup-
ported on casters.
Figure 19. 2x4 Placed beneath machine and
13. Attach swivel casters to each front bracket
with (4) M8-1.25 x 16 hex bolts and (4)
M8-1.25 lock nuts (see Figure 16).
Note: There is limited space when install-
ing fasteners inside the bottom of the caster
wheels.
x 4
secured.
12" 2x4
mobile base frame.
T31566 Mobile Base (Mfd. Since 08/19)
Advertisement
