Advertisement
2.
Attach each foot pedal to corner bracket
with (1) M8-1.25 x 50 shoulder bolt and (1)
M8-1.25 lock nut (see Figure 11).
Foot
Pedal
Figure 11. Attaching foot pedals.
3.
Insert one side rail into the two front brackets,
as shown in Figure 12, then slide the bracket
assembly against the side of machine that
will typically be pushed against when moving
the machine.
Corner Brackets
with Rubber Feet
Side Rail
Figure 12. Rail inserted between corner
brackets.
x 2
Figure 13. Rail secured to corner brackets.
T31566 Mobile Base (Mfd. Since 08/19)
x 2
4.
Secure each end of rail to front brackets
with (2) M8-1.25 x 16 hex bolts, as shown in
Figure 13.
5.
Slide other side rails into front brackets from
Step 4. Secure rails to front brackets with (4)
M8-1.25 x 16 hex bolts, as shown in Figure
14.
Figure 14. Rails fastened to brackets (machine
removed for clarity).
6.
While an assistant lifts one side of the
machine, slide rail-bracket assembly from
Step 5 under machine, as shown in Figure 15.
Note: It may be necessary to adjust position
of rails once machine is on base assembly.
Side rails may be cut down to accommodate
machines with smaller footprints. However,
reducing length of mobile base decreases
stability and increases likelihood of tipping.
Base plates should be constructed for tall or
top-heavy machines (see Page 9).
Rail-Bracket
Assembly
Figure 15. Rail-bracket assembly placed under
front of machine.
x 4
-5-
Advertisement
