Grizzly T32796 Instructions

For questions or help with this product contact Tech Support at (570) 546-9663 or techsupport@grizzly.com
Introduction
The Model T32796/T32797 Knife Sharpening
Jigs are fixtures designed to work with the Model
T32720 10" Wet Grinder. The Model T32796 is
for blades longer than 4" while the Model T32797
supports blades that are shorter than 4".
To reduce your risk of
serious injury, read this
entire
using machine.
Figure 1. Example of Model T32796 in use.
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
manual BEFORE
COPYRIGHT © JULY, 2021 BY GRIZZLY INDUSTRIAL, INC.
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
(FOR MODELS MFD. SINCE 07/21) #CS21971 PRINTED IN CHINA
MODEL T32796/T32797
KNIFE SHARPENING JIGS
FOR T32720 WET GRINDER
INSTRUCTIONS
Inventory
Description
A. Jig (T32797 Shown) ................................... 1
B. Knob Bolt M6-1 x 20 ................................... 1
A
Figure 2. Inventory.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Qty
B
V1.07.21