JB Systems USB PARTYSET Operation Manual page 8

ENGLISH
5) CONTROLLED VIA THE IR REMOTE CONTROLLER:
The USB PARTYSET can be controlled by the IR remote control that is supplied with your USB effect
IMPORTANT: check if the remote control option is activated (ON) in the System settings of the bar. If this
option is switched off, you can not use the IR remote control. (see last chapter)
SOUND MIX
PROGRAM
The other buttons are not used.
6) CONTROLLED VIA DMX:
The USB PARTYSET can be controlled by any standard DMX-controller in 4 different DMX-modes:
• 4 CHANNEL MODE: for easy control over the automatic and sound modes
• 7 CHANNEL MODE: to control the Color, Strobe, Dimmer and motor rotation manually
• 10 CHANNEL MODE: control over the automatic and sound modes + general manual control
• 34 CHANNEL MODE: control over the automatic and sound modes + full manual control over
each individual projector.
• Connect the DMX input of the USB PARTYSET to the DMX output of the previous unit in the chain or
directly to the DMX-output of your controller.
• Press the [MENU] button until the display shows: "DMX".
• Press the [ENTER] button to enter this option
• The actual DMX address is shown on the display.
• Press the [ENTER] button again to set the DMX settings
JB SYSTEMS®
press the button to select one of the different
AUTO MIX
mixed automatic shows: AM01, AM02, ....
press the button to select one of the different
mixed sound controlled shows: SM01, SM02,
press the button to start up the effect bar or
ON/OFF
EFFECT press the button to pause (freeze) the
PAUSE
Each time you press this button you will
AUTO P activate another automatic program.
Each time you press this button you will
SOUND P
press number 0 to 9 to select the desired
speed for the automatic programs (not sound
SPEED
controlled). 0= slowest, 9= fastest
to put the bar in standby mode
running effect
AP01, AP02, ...
activate another sound program.
SP01, SP02, ...
6/12
USER MANUAL
USB PARTYSET