Hartzell HC-E4 3 Series Owner's Manual page 98

CAUTION 1:
CAUTION 2:
CAUTION 3:
A flange propeller mounting bolts
(except E5A-2)
E5A-2 flange
propeller mounting nuts
B flange propeller mounting bolts
N flange propeller mounting bolts
except HC-E(4,5)N-(3,5)K(L)
N flange propeller mounting nuts
HC-E(4,5)N-(3,5)K(L)
P flange propeller mounting bolts
except HC-E5P-3
HC-E5P-3
propeller mounting nuts
W flange propeller mounting nuts
Adapter Plate to Hub bolts -
B-3384-4H
Slip Ring and adapter Plate Unit
to Hub screws - A-2070-7
Bulkhead to Adapter Plate
screws -B-3867-269
Pulley to Adapter Ring -
Pilatus fastener
Balance weight screws or bolts-
Aircraft quality #10-32 or AN-3( )
INSTALLATION AND REMOVAL
Propeller Owner's Manual
FOR A PROPELLER THAT DOES NOT USE A
LUBRICATED (WET) TORQUE, THE MOUNTING
HARDWARE MUST BE CLEAN AND DRY TO
PREVENT EXCESSIVE PRELOAD OF THE
MOUNTING FLANGE.
TORQUE VALUES WITH "WET" NOTED AFTER
THEM ARE BASED ON LUBRICATED THREADS
WITH APPROVED ANTI-SEIZE COMPOUND
MIL-PRF-83483( ).
REFER TO FIGURE 3-2 FOR TORQUE READING
WHEN USING A TORQUE WRENCH ADAPTER.
Torque Table
Table 3-2
147
100-105 Ft-Lbs (136-142 N•m) Wet
120-130 Ft-Lbs (163-176 N•m) Wet
100-105 Ft-Lbs (136-142 N•m) Wet
100-105 Ft-Lbs (136-142 N•m) Wet
120-130 Ft-Lbs (163-176 N•m) Wet
100-105 Ft-Lbs (136-142 N•m) Wet
120-130 Ft-Lbs (163-176 N•m) Wet
120-125 Ft-Lbs (163-170 N•m)
8-10 Ft-Lbs (10.8-13.5 N•m)
8-10 Ft-Lbs (10.8-13.5 N•m)
8-10 In-Lbs (0.9-1.1 N•m)
48 In-Lbs (5.4 N•m)
30-36 In-Lbs (3.4-4.0 N•m)
61-00-47
Page 3-8
Rev. 17 Sep/20