Hartzell HC-E4 3 Series Owner's Manual page 112

(16) Install, adjust, and safety the beta linkage per the airframe
manufacturer's instructions, if applicable.
(17) If the propeller is equipped with an accessory drive pulley,
follow the applicable manufacturer's instructions for
installation of the accessory drive pulley hardware.
(18) If the propeller is equipped with an ice protection
system that uses components supplied by Hartzell
Propeller Inc., applicable instructions and technical
information for the components supplied by Hartzell
Propeller Inc. can be found in Hartzell Propeller Inc. Ice
Protection System Manual 180 (30-61-80).
(19) Propeller ice protection system components not
supplied by Hartzell Propeller Inc. are controlled by the
applicable TC or STC holder's Instructions for Continued
Airworthiness (ICA).
(20) Install the propeller spinner dome in accordance with the
section "Spinner Dome Installation" in this chapter.
CAUTION:
(21) If applicable, cut the protective cover BST-2816-7 to
remove it from the beta ring.
(a) Retain the protective cover BST-2816-7 for use when
removing the propeller
INSTALLATION AND REMOVAL
Propeller Owner's Manual
USE EXTREME CARE TO AVOID
SCRATCHING, NICKING, OR DAMAGING
THE BETA RING.
147
61-00-47
Rev. 17 Sep/20
Page 3-22