Hartzell HC-E4 3 Series Owner's Manual page 123

CAUTION:
(15) Install the carbon block assembly into the beta ring.
Refer to Figure 3-6.
(16) Install, adjust, and safety the beta linkage in accordance
with the airframe manufacturer's instructions.
(17) If the propeller is equipped with an accessory drive
pulley, follow the applicable manufacturer's instructions
for installation of the accessory drive pulley hardware.
(18) If the propeller is equipped with an ice protection system
that uses components supplied by Hartzell Propeller Inc.,
applicable instructions and technical information for the
components supplied by Hartzell Propeller Inc. can be
found in Hartzell Propeller Inc. Ice Protection System
Manual 180 (30-61-80).
(19) Propeller ice protection system components not
supplied by Hartzell Propeller Inc. are controlled by the
applicable TC or STC holder's Instructions for Continued
Airworthiness (ICA).
(20) Install the propeller spinner dome in accordance with the
section, "Spinner Dome Installation" in this chapter.
INSTALLATION AND REMOVAL
Propeller Owner's Manual
FIT THE BLOCK IN THE BETA RING WITH
A SIDE CLEARANCE OF 0.001 TO
0.002 INCH (0.03 TO 0.05 mm). REFER TO
FIGURE 3-6.
147
61-00-47
Rev. 17 Sep/20
Page 3-33