Hartzell HC-E4 3 Series Owner's Manual page 136

WARNING:
(2) Using Quick Dry Stoddard Solvent or MEK, clean the
engine flange and the propeller flange.
(3) Remove the pitch change rod cap, if applicable.
(4) Install the specified O-ring on the engine flange. Refer to
Table 3-1.
(5) Align the mounting and dowel pin holes in the propeller
hub flange with the mounting holes and dowel pins in the
engine flange.
(6) Slide the propeller flange onto the engine flange.
CAUTION 1:
CAUTION 2:
(7) Apply MIL-PRF-83483( ) (Hartzell Propeller Inc. Part
No. A-3338-[ ]) anti-seize compound to the threaded
surfaces of the mounting bolts. Refer to Table 3-1 for the
appropriate mounting hardware.
NOTE:
INSTALLATION AND REMOVAL
Propeller Owner's Manual
SOLVENTS ARE FLAMMABLE AND
TOXIC TO THE SKIN, EYES, AND
RESPIRATORY TRACT. SKIN AND EYE
PROTECTION ARE REQUIRED. AVOID
PROLONGED CONTACT AND BREATHING
OF VAPORS. USE SOLVENT RESISTANT
GLOVES TO MINIMIZE SKIN CONTACT
AND WEAR SAFETY GLASSES FOR
EYE PROTECTION. USE IN A WELL
VENTILATED AREA AWAY FROM SPARKS
AND FLAME. READ AND OBSERVE ALL
WARNING LABELS.
MAKE SURE THAT COMPLETE AND TRUE
SURFACE CONTACT IS ESTABLISHED
BETWEEN THE PROPELLER HUB
FLANGE AND THE ENGINE FLANGE.
NEW PROPELLER MOUNTING BOLTS
MUST BE USED WHEN INITIALLY
INSTALLING A NEW OR OVERHAULED
PROPELLER.
If the propeller is removed between overhaul
intervals, mounting bolts and washers may be
reused if they are not damaged or corroded.
147
61-00-47
Rev. 17 Sep/20
Page 3-46