Paper Gets Jammed - Epson ET-5170 Series User Manual

Solving Problems
Error Messages
Printer Error
Turn on the printer again. See your
documentation for more details.
Paper out in XX.
Paper Setup Auto Display is set to Off. Some
features may not be available. For details, see
your documentation.
No dial tone is detected.
The combination of the IP address and the
subnet mask is invalid. See your documentation
for more details.
To use cloud services, update the root certificate
from the Epson Web Config utility.
Check that the printer driver is installed on the
computer and that the port settings for the
printer are correct.
Check that the printer driver is installed on the
computer and that the USB port settings for the
printer are correct.
Recovery Mode

Paper Gets Jammed

Check the error displayed on the control panel and follow the instructions to remove the jammed paper including
any torn pieces. Next, clear the error.
Important:
c
❏ Remove the jammed paper carefully. Removing the paper vigorously may cause damage to the printer.
❏ When removing jammed paper, avoid tilting the printer, placing it vertically, or turning it upside down;
otherwise ink may leak.
>

Paper Gets Jammed

Solutions
Remove any paper or protective material in the printer. If the error
message is still displayed, contact Epson support.
Load paper, and then insert the paper cassette all the way.
If Paper Setup Auto Display is disabled, you cannot use AirPrint.
This problem might be resolved by selecting Settings > General
Settings > Fax Settings > Basic Settings > Line Type and then
selecting PBX. If your phone system requires an external access code to
get an outside line, set the access code after selecting PBX. Use # (hash)
instead of the actual access code when entering an outside fax number.
This makes connection more secure.
If the error message is still displayed, set the Dial Tone Detection
settings to disabled. However, disabling this feature may drop the first
digit of a fax number and send the fax to the wrong number.
Enter the correct IP address or default gateway. Contact the person who
setup the network for assistance.
Run Web Config, and then update the root certificate.
Make sure the printer port is selected correctly in Property > Port from
the Printer menu as follows.
Select "USBXXX" for a USB connection, or "EpsonNet Print Port" for a
network connection.
The printer has started in recovery mode because the firmware update
failed. Follow the steps below to try to update the firmware again.
1. Connect the computer and the printer with a USB cable. (During
recovery mode, you cannot update the firmware over a network
connection.)
2. Visit your local Epson website for further instructions.
184