Advertisement
Stored/Reset Error Codes Screen
Figure 16
1. Number of errors and
number of reset errors
2. Reset error
The following figure is an example of how an error code
appears.
Notice that the text before the occurrence count entails what
the actual error is.
Figure 17
1. Number of errors and
number of reset errors
2. Next error
g029854
3. Next error
g029855
3. Reset error
Diagnose and Update Screen
Access this screen from the
Software versions K and up only: use this screen to
calibrate the loader cams
Software versions V and up only: use this screen to the
auto throttle option
(Figure
1. Auto throttle
Press button 6 to turn the auto throttle option O
and O
(red).
FF
Note: The time setting disappears in OFF option.
The auto throttle can only be used when the machine is in
D
mode. It does not operate when the machine is set to
RILL
travel mode.
The auto throttle is initiated when the ON option is selected
and the engine rpm exceeds 2300 rpm.
Operating the engine below 2300 rpm remains a manual rpm
selection regardless if the auto throttle is OFF or ON.
Press the left and right arrow buttons to set the time from 10
to 60 seconds. The settings are maintained when the machine
is shut down.
All functions must be off (mud, drilling, elevator, and
wrenches) for the time period set before the engine will
rescind to idle. Movement of any of the functions (mud,
drilling, elevator, and wrenches) will return the engine to
2800 rpm.
7
Carriage-Pressure Screen (page
(Figure
18) as described in
18).
Figure 18
N
4).
Figure
26.
g200497
(green)
Advertisement
