Table of Contents
Advertisement
Chapter 5. Configuration Menu
Subnet
Mask
Default
Router
SLIP Rate
SLIP Flow
CTL
Proxy Traps Enables or disables the transmission of trap mes-
5-10
Defines which part of a destination IP address is
the network number. Used along with the TSU
600e IP address to determine which nodes must
be reached through the default IP Gateway.
This value is set to 0.0.0.0 when the IP interface
option is set to SLIP.
All IP Packets destined for nodes not on the TSU
600e unit's local network are not forwarded
through this IP address. Normally, this address
defines a router connected to the TSU 600e unit's
local network. This value is ignored when the IP
interface is set to SLIP.
Sets the baud rate for the Chain-In port when
used as the SLIP connection for SNMP manage-
ment.
Choices: 1200, 2400, 4800, 9600, 19200, 38400
Used to activate flow control on the Chain-In
port when used as the SLIP interface. Hardware
mode uses RTS and CTS.
Choices: None, Hardware
sages from units being "proxied" for.
Choices: Enable, Disable
TSU 600 User Manual
61202076L1-1
Advertisement
Table of Contents
