Compressor Assembly; Setting Up; Maximum Permissible Inclination - BOCK FK40 Series Assembly Instructions Manual

4| Compressor assembly

INFO

4.1 Setting up

WARNING
Transport and suspension unit on the eyebolt (Fig . 4) or direct on the discharge line valve
(Fig. 5).
Fig. 4
Storage at (-40°C) - (+100°C), maximum permissible relative humidity 10% - 95%, no
condensation.
Fittings (e.g. pipe holders, additional units etc.) on the compressor are permissible only
following consultation with Bock.
Setup on an even surface or frame with sufficient load-bearing capacity. Use all 4 fastening
points.
Correct setup of the compressor and mounting of the belt drive are decisive for running comfort,
operating safety and the service life of the compressor.

4.2 Maximum permissible inclination

ATTENTION Poor lubrication can damage the compressor. Respect the stated
A
a
Fig. 6
New compressors are factory-filled with inert gas. Leave this ser-
vice charge in the compressor for as long as possible and prevent
the ingress of air.
Check the compressor for transport damage before starting any
work.
Move compressors only with hoists that have adequate load-bear-
ing capacity.
values.
A A
a
Fig. 5
A
a a
max. 30°,
A
max. 2 minutes
max. 15°,
a
continuous
operation
D
GB
F
E
PT
I
TR
Ru
9