Replacement Parts; Disposal Note; Fault / Cause / Remedy - Grohe 36366 Manual

Hide thumbs Also See for 36366:

Manual (14 pages)

Table Of Contents

Table of Contents

Available languages

Signalling the remaining battery capacity and performing

thermal disinfection

Turn mixer lever to the hot water end stop.

Thermal disinfection is started and the remaining battery

capacity is signalled by holding the finger against the lower area

of the sensor system (indicator lamp lights up continuously, then

flashes slowly, then flashes quickly). Remove the finger when

the quick flashing signals start. The remaining battery capacity

is signalled as follows by the number of flashing signals:

4 = Remaining capacity > 60%

3 = Remaining capacity > 40%

2 = Remaining capacity > 20%

1 = Remaining capacity < 20%

Thermal disinfection starts once the remaining capacity has

been signalled.

The detection zone of the sensor system must be

kept clear while the remaining battery capacity is

being signalled.

If an object is detected during thermal disinfection (hot water

flow), the water stops flowing immediately and the fitting is

closed (indicator lamp starts to flash).

Closure of the fitting ends automatically after 3 minutes or can

be prematurely terminated (see Terminating cleaning mode).

Fault / Cause / Remedy

Fault

Water not flowing

Water flowing

continuously

Undesired water

flow

Flow rate too low

Cause

• Water supply interrupted

• Filter in solenoid valve blocked

• Solenoid valve defective

• Plug-in connector of solenoid valve without

contact

• No voltage

- Battery discharged

- Plug-in connector without contact

• Hands not in detection zone

• Cleaning mode activated

• Solenoid valve defective

• Thermal disinfection activated

• Automatic flushing activated

• Mousseur dirty

• Filter in solenoid valve dirty

• Filters in connection hose dirty

• Shut-off valves, service valves not fully open

• Water supply restricted

Shut off hot and cold water supply.

Inspect and clean all components and replace if necessary.

I. Battery, see page 4, Fig. [13] and [14].

Batteries which are almost discharged are displayed by

a flashing indicator lamp in the sensor system.

II. Mixer spindle, see page 4, Fig. [15] - [18].

III. Solenoid valve, see page 5, Fig. [19] - [25].

Assemble in reverse order.

Observe correct installation position of individual

components, see details, Fig [25].