Table of Contents
Advertisement
health reasons and also because the
belt will clog and poor surface finish will
result. It is not possible to be exact when
recommending the size of dust collector
to be used; this will depend on the type
of work that the machine is used for.
It is recommended that a dust collector
with a minimum of 3500 cubic feet/minute
be attached to the sander.
8. Air supply
A clean, dry air supply with a minimum
pressure of 6 bar must be connected to
the sander. If the pressure drops below
5 bar, the machine will stop functioning.
9. Electrical control box
The electrical control box houses all the
electrical control components and must
never be opened while power is
supplied to the machine.
10. Conveyor motor and gearbox
11. Conveyor
The conveyor is a continuous rubber
belt that transports the job past the
sanding head.
Contactors
Amp meter current sensor
Power input terminals
Fuses
10
8
Power cable gland
11
9
10
Advertisement
Table of Contents
