Honeywell CentraLine EAGLEHAWK NX User Manual page 21

EAGLEHAWK NX CONTROLLER
11. Turn the rotate&push button to change the hours. Then push the rotate&push
button.
The minutes field is flashing.
12. Set the minutes in the same way as the hours.
After finally pushing the rotate&push button, the time is highlighted and set.
13. Turn the rotate&push button to navigate to and highlight the value.
14. Then push the rotate&push button.
The Ones are flashing.
15. Turn the rotate&push button to change (increase or decrease) the value.
Higher digits of the value are automatically increased or decreased.
16. Push the rotate&push button. The new value is displayed and the cursor
jumps to an OK field which displays.
At this point you can pre-save the value, or you can switch to digits before or
after the decimal place which are not displayed initially by the original value.
To pre-save the value, please refer to step 17.
To display and adjust lower digits (tenths, hundreds. etc.) or higher digits
(any higher than the original), please refer to step 18.
17. Push the rotate&push button while the OK field is highlighted.
The changed value is highlighted.
To save the value, please refer to step 21.
21
BASIC OPERATION PROCEDURES
EN2Z-1053GE51 R0119