Page 1
Traction Plate Spring Traction Grip Adjustment Knob Footboard Upper Nut Power Shifter Lower Nut Anchor Screw Wing Bolt (for Hoop Clamp) Power Plate Belt Guide Heel Plate Belt NOTE: The P-1000 comes with a Single Chain attached at the factory.
Page 2
Convertible Single Chain/Belt Drive System Quad Beater The P-1000 comes with a Single Chain attached at the The Quad Beater has four striking factory, however, it can be replaced with the included Belt if surfaces, each capable of producing desired.
Page 3
Footboard Angle Adjustment Traction Plate and Traction Grip Adjustment The footboad angle is adjustable by loosening the Key Bolt The Traction Plate is reversible to provide just the right as shown ( Fig. 8 ) and sliding the Drive Connector of the amount of grip at either the front or rear of the footboard.
Page 4
Hoop Clamp System Caution To attach your pedal to the bass drum, slide the bass drum hoop between the Hoop Clamp and the bottom lip of the Take care when handling or moving the fully assemble pedal. Square the pedal then tighten the Wing Bolt to Twin Pedal to prevent damage to the Drive Shaft and secure the pedal to the bass drum.
Need help?
Do you have a question about the P-1000 and is the answer not in the manual?
Questions and answers