3Com IntelliJack NJ105 User Manual page 29

To connect the local power supply to the IntelliJack, follow these
steps (as shown in the previous diagram):
1 Route the power cable through the strain relief on the top
of the IntelliJack.
2 Plug the power cable into the IntelliJack.
3 Check to ensure that the cable is secure in the strain relief.
4 Route the cable behind the trim ring from top to bottom.
5 Secure the local power supply and cable to the wall.
6 Plug the local power supply into the power source.
WARNING: Use the local power supply
available from 3Com. Failure to do so may result
in damage to the IntelliJack, or may result in a
hazardous situation.
Using the 3Com Local Power Supply
25