Hook Flash Timer (Flash 31); Attendant Recall Timer (Flash 33); To Program Page B Features - LG GHX-308A/616 Installation And Programming Manual

GHX-308A/616
HYBRID KEY TELEPHONE SYSTEM
Pulse speed (20 pps).
LED on : DTMF, UNA, Toll override, Ground Flash, Pulse Ratio (60/40), Pulse Speed (10 pps)
6.
When the attributes are being programmed, button 1 through 6 can be toggled On or Off. Buttons 7
through 8 require numeric entries form the dial pad. The toggled buttons can all be set and then
entered as a block with the HOLD button. Each button with a numeric entry requires a pressing of the
HOLD button to store the data. Each time the HOLD button is pressed, the display will refresh with
the new data.
7. To program PAGE B features, use the button as follows:
FLASH
TIME
PAGE
A
8. Buttons 1 and 2 require numeric entries form the dial pad. The toggled buttons can all be set
and then entered as a block with the HOLD button. Each button with a numeric entry requires a
pressing of the HOLD button to store the data. Each time the HOLD button is pressed, the display
will refresh with the new data.
9. Pressing button 11(Next Forward) steps to the next CO line higher than the upper limit of
the present CO range. Pressing button 12(Next Backward) steps to the lower CO range
present range. Subsequent presses of button 11 and 12 will continue to step to the next CO range.

HOOK FLASH TIMER (FLASH 31)

When single line telephones are connected to the system, this time determines how long the user should depress the
hook switch in order for it to be considered a Flash.
Parameters:
Determines the time range to be considered as hook flash signal. The time variable from 100 msec to 2 seconds.
Range: 01-20 (x100 msec)
Default: 05 (x100 msec)
Procedure:
1. Press FLASH button dial 31.
2. On a display phone, you will see this display:
HOOK FLASH TIME 01-20
05
3. Enter 2 digits on the numeric keypad.
4. Press HOLD button.

ATTENDANT RECALL TIMER (FLASH 33)

A CO line placed on hold or transferred or parked will initiate the recall timer if the associated timer has been enabled
in programming. When the timer expires, the CO line will ring the station that placed it on hold. If not answered, the
associated timer continues and upon expiration again the attendant station will ring.
Http://suryawardana.com
LINE
GROUP
PAGE NEXT
B FORWARD
DISA
(GHX-616 only)
NEXT
BACKWARD
82
than the