Automatic Call Number Redial (Ghx-616 Only); To Activate Automatic Call Number Redial; To Deactivate Automatic Call Number Redial; Ringing Line Preference - LG GHX-308A/616 Installation And Programming Manual

GHX-308A/616
HYBRID KEY TELEPHONE SYSTEM

Automatic Call Number Redial (GHX-616 only)

This feature allows a station user put himself into an Automatic Redial Mode to automatically call back a busy number or
no answer number on outgoing CO/PBX lines by pressing a flexible button programmed as ACNR feature ( REDIAL
button for GK-24/36 S/E keyset user). The maximum number of automatic redial retry is 3 times with time interval 030-
255 sec.

To activate Automatic Call Number Redial;

While hearing busy tone after placing a CO call, press the ACNR button (REDIAL button for GK-24/36 keyset user)
and go on-hook.

To deactivate Automatic Call Number Redial;

Press flashing ACNR button. ( REDIAL button for GK-24/36 keyset user)
Programming
1. FLASH 38 (GHX-616) : Auto Redial Timer (30-255 seconds)
Feature Code
1. SPD* : Last Number Redial
2. 750, 75# (SLT in GHX-308A) : Last Number Redial
3. 750, ## (SLT in GHX-616) : Last Number Redial
4. SPD # : Save Number (Memo) Redial
5. 774 : Dial Memo (Button assignment only)
6. 767 (GHX-616 only) : Automatic Call Number Redial (Button assignment only)

RINGING LINE PREFERENCE

Description
A station with ringing line preference can answer any assigned ringing CO line by simply lifting the handset or pressing
the MON button.
Programming
1. Flash 40, Page A, Button 5 : Preferred Line Answer Enable/Disable
SPEED DIAL
Description
The system allows following two kinds of Speed Dial;
1) Station Speed Dial
Up to 20 station speed numbers are programmed by individual station.
2) System Speed Dial
Up to 80 commonly dialed system speed numbers are programmed by system attendant for use by stations
allowed this feature. The last 40 numbers(bin 60-99) will not be monitored by toll restriction.
Numbers are dialed by use of the Speed Dial code.
Speed bin 00 can be used to program user's name so that it appears on calling/called display phones instead of
station number.
Operation
(Keyset)
To program special commands;
- for Pause, press the HOLD button.
- for Flash, press the FLASH button.
- for Pulse-to-Tone switch-over, press the TRANS button.
To store station speed numbers (at Station) or
Http://suryawardana.com
54