Dhcp C Lient; Orkstation To; Workstation Configuration Using Dhcp Smart Mode - 3Com OfficeConnect 3CP4144 Get Started Manual
3com officeconnect 3cp4144: user guide
Hide thumbs
Also See for OfficeConnect 3CP4144:
- Cli user's manual (144 pages) ,
- How to set up (4 pages) ,
- Release note (2 pages)
Table of Contents
Advertisement
C
ONFIGURING
B
W
DHCP C
Workstation Configuration Using DHCP Smart Mode
If you have chosen to utilize DHCP Smart Mode, you will
need to configure some parameters on your workstation.
You should set up the workstations on the OfficeConnect
Remote 812's LAN to automatically obtain their IP address.
This is the default setting in Windows 95.
If you have configured IP addresses manually on your LAN,
you should use the following procedure on each
workstation to allow them to automatically learn the new
addresses instead
The following is an example of this procedure on a
workstation running Windows 95.
1 Open the Control Panel. Select Network > Configuration
> TCP/IP to access the TCP/IP Properties Menu.
Select the Gateway tab. Remove any IP addresses in the
Installed Gateways field.
Y
ORKSTATION TO
LIENT
OUR
B
E A
Advertisement
Table of Contents
Need help?
Do you have a question about the OfficeConnect 3CP4144 and is the answer not in the manual?
Questions and answers